CNC Bender v11-20091229

From ATTWiki
Revision as of 22:15, 30 December 2009 by Mcone (Talk | contribs)

Jump to: navigation, search

Cncbender logo pushbending.png

Type of Upgrade: Optimization and New Feature

The changes in this version are designed to make CNC Bender more accurate and run faster.

Operatorstation model.jpg

Contents


Check.jpg ENHANCE- Updates to CNC Processor to improve motion command logic

  • There were circumstances were incremental motion commands could be issued twice when only one command was necessary.

  • This version of CNC Bender removes the potential for double calls to incremental motion commands

Bendarm blur vb150.jpg



Check.jpg CHANGE- PreBend Rotate to Start Angle User-Interface Change

  • The PreBend ROTATE TO START ANGLE feature is now only available in the PreBend Dynamic Options list

  • This reduces confusion so that the operator knows that the feature is available in a single location.

Rotatetostart dynamicoption.jpg

Prebendcarriagemenu removed rotate to start.jpg



Check.jpg NEW - Tube Mandrel Check and Destroyer Feature

  • CNC Bender can now automatically check for the existence of a broken mandrel after a mandrel extraction.

  • If the mandrel is broken, then CNC Bender process list logic requires the operator to place the tube in a tube destroyer to crush the tube to prevent it from being used in other machinery in the cell.

Tubedestroyer.jpg

Mandrelcheck actuator.jpg



Other Pages