• CNC Bender now allows logic to make a physical momentary push-button into a toggle switch. For example, push the button to switch a state on, then push it again to switch the state off.
  
  

• For example, it is possible to use logic in the Constant Run processlist to switch a End Cycle ON and OFF using a push button.
  
  
• It is also possible to illuminate the button according to the current End Cycle state.

• Edge triggers now work when repeating the same inputs in the [IF] and [IFNOT] commands.
  
  

• If an edge triggerized input is true in an IF line, then the edge trigger is CLEARED - UNLESS the entire set of logic in that parameter line returns FALSE as a whole. In that case the edge trigger is set back to TRUE (it is SET).

• This allows for multiple uses of the same input in processlists - like in the Constant Run processlist.

[if] AND,  input=Input_EndOfCycle_Button_End, output=not(Output_IBR_EndCycleSignal_Constant)
 Set_EndCycle_ON
[end]

[if] AND,  input=Input_EndOfCycle_Button_End, output=Output_IBR_EndCycleSignal_Constant
 Set_EndCycle_OFF
[end]

• Messages now display for missing High Speed Constant Run Processlist
  
  

• New grid source with improvements for better performance.

• The part count updated normally except when the Runlist Run is complete. This is corrected.