CNC Bender v11-20091118

Type of Upgrade: FASTER BENDING The changes in this version are minor debugs to the November 4, 2009 version of CNC Bender - Speed optimizations. (See CNC Bender v11-20091104 and CNC Bender v11-20090518)

REPAIR- Final Bend Simultaneous Motion

If the final Bend Return Step Point is ZERO, then the standard "BendAbsolute" command is now called correctly without generating errors during AutoBuild. This switches the immediate move "Bend Absolute" off - which makes CNC Bender wait for the bend arm to completely return home before moving to the next step in the process.

REPAIR- Time-Out Value for Bend Arm Return

The bend arm return timeout value was accidentally set to the Run Buttons timeout in the previous version. This has been resolved so that the axis timeout value is once again used.

ENHANCE - AllDiesToHome Command and AllDiesToHomeWithoutPDA Commands

Both of these commands can now be named in the General Dynamic Option List in Low Level.
When returning a PDA motion-controlled axis... When using a FOLLOWER with NO prox...	...then AllDiesToHomeWithoutPDA is called immediately after in order to insure that the pressure die and clamp dies are home before continuing.
When returning a PDA directional valve actuator... When returning a FOLLOWR with a prox switch...	...then AllDiesToHome is called to be sure the pressure die, clamp die, and Pressure Die Assist die are home before continuing.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender v11-20091104
• See CNC Bender General Information
• See Absolute Rotate
• See Absolute Rotate Offset Position
• See Final Feed Clearance
• See Mandrel Retract
• See Mandrel Retract Part Release