Revision as of 12:55, 19 November 2009

Type of Upgrade: FASTER BENDING

The changes in this version are minor debugs to the November 4, 2009 version of CNC Bender - Speed optimizations. (See CNC Bender v11-20091104 and CNC Bender v11-20090518)

If the final Bend Return Step Point is ZERO, then the standard "BendAbsolute" command is now called correctly without generating errors during AutoBuild.
This switches the immediate move "Bend Absolute" off - which makes CNC Bender wait for the bend arm to completely return home before moving to the next step in the process.

The bend arm return timeout value was accidentally set to the Run Buttons timeout in the previous version.
This has been resolved so that the axis timeout value is once again used.

Both of these commands can now be named in the General Dynamic Option List in Low Level.

When returning a PDA motion-controlled axis, then AllDiesToHomeWithoutPDA is called immediately after in order to insure that the pressure die and clamp dies are home.

@@ Line 71: / Line 71: @@
 </td>
-<td>
+<td width=300>
-* When returning a PDA motion-controlled axis, then AllDiesToHomeWithoutPDA is called immediately after in order to insure that the pressure die and clamp dies are home.
+# When returning a PDA motion-controlled axis, then AllDiesToHomeWithoutPDA is called immediately after in order to insure that the pressure die and clamp dies are home.
 </td>

Difference between revisions of "CNC Bender v11-20091118"