CNC Bender v11-20091104

NEW - Final Bend Simultaneous Motion

The final bend arm return motion now allows logic to continue even if it is still moving back. The Bend Return Step Point value in the last row controls when the final bend arm return will release the processlist to move back to the beginning of the program.

NEW - New Optimization in Processor - Makes Bender Run Faster

A new [BEGIN RUN AGAIN] label is used to trim off processing time by bypassing commands that only need to be run once at the top of each process list. (bend program) The result is to potentially trim seconds of each cycle.

NEW - HIGH SPEED Constant Run List

USe the new high-speed constant run list for processes that should run all the time and get high attention. Control the interval of how often the list runs in the Processor tab in the Low Level menu. The list file is separate from the ConstantRun processlist. The name is "ConstantRunHS.processlist"

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender General Information
• See Absolute Rotate
• See Absolute Rotate Offset Position
• See Final Feed Clearance
• See Mandrel Retract
• See Mandrel Retract Part Release