Revision as of 22:28, 4 November 2009

The final bend arm return motion now allows the process list that follows to begin even if the bend arm is still returning home.
The Bend Return Step Point value in the last row controls when the final bend arm return will release the processlist to move back to the beginning of the program.

A new [BEGIN RUN AGAIN] label is used to trim off processing time by showing CNC Processor where to start in the middle of the process list for a part. This can bypasses an initialization section that may contain 50 commands that are only needed to be run once at the top of each process list. (bend program)
The result is to trim seconds of each cycle.

USe the new high-speed constant run list for processes that should run all the time and get high attention.
Control the interval of how often the list runs in the Processor tab in the Low Level menu.

The list file is separate from the ConstantRun processlist. The name is "ConstantRunHS.processlist"

Put tube-support control in this list to make it more responsive to fast moving Feed axes.

@@ Line 30: / Line 30: @@
 <tr>
 <td width=300>
-* A new [BEGIN RUN AGAIN] label is used to trim off processing time by bypassing commands that only need to be run once at the top of each process list. (bend program) <br><br>
+* A new [BEGIN RUN AGAIN] label is used to trim off processing time by showing CNC Processor where to start in the middle of the process list for a part.  This can bypasses an initialization section that may contain 50 commands that are only needed to be run once at the top of each process list. (bend program) <br><br>
-* The result is to potentially trim seconds of each cycle.
+* The result is to trim seconds of each cycle.
 </td>

Difference between revisions of "CNC Bender v11-20091104"