Difference between revisions of "CNC Bender v11-20090827"

From ATTWiki
Jump to: navigation, search
(25px NEW - CYCLE HOLD for Secondary Processes -)
(Other Pages)
Line 27: Line 27:
 
*Back to [[CNC Bender Software Updates]]
 
*Back to [[CNC Bender Software Updates]]
 
*See [[Cycle Hold]]
 
*See [[Cycle Hold]]
 +
*See [[Hopper Logic]]

Revision as of 15:39, 28 August 2009

Cncbender logo pushbending.png

Operatorstation model.jpg


Check.jpg NEW - CYCLE HOLD for Secondary Processes

In previous versions, "[CYCLEHOLD]" had no effect inside secondary processes that control devices around the bender. Now hoppers and side loaders can put the entire cell into the regular cycle hold state.

This is a snippet from a secondary processlist that shows this feature in action:

[IF] AND, input=not(Input_AutoLoader_PartPresent_End), input=Input_AutoLoader_PartPresent2_End, output=not(Output_AutoLoader_GripperClose_Constant)
 
 [Immediate_Message] AUTOLOADER PART NEST JAMMED - Entering CYCLE HOLD
 [CYCLEHOLD]

[END]

Check.jpg ENHANCED - AutoLoader Timeout is Tied to Robot Timeout

The Robot Timeout value in the Low Level dynamic options is now used to control the AutoLoader timeouts.


Other Pages