Difference between revisions of "CNC Bender v11-20090605"
From ATTWiki
Revision as of 13:58, 8 June 2009
Contents |
FIX - [IF] Logic Repaired
When calculating the low/high position range to determine if the horizontal head should move into position, the horizontal offset value (low level adjustment) was added twice into the values during process list building. This caused the horizontal head to shift even if it was in the correct position. This update resolves that issue.
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- Read about Push Bending
- Read about Push Bend Profile Tables
