CNC Bender v11-20090126

ENHANCE - Adjust General Dynamic Option Name - Feed-Bend Torque Limits

The Low Level names of dynamic options "Feed Torque Safe High" and "Feed Torque Safe Low" were adjusted for clarification.

The new names include "Feed-Bend" inserted in the beginning to be sure users understand that these values are used by the Processlist Builder to limit the feed axis torque during Feed-Bending only. These values have no effect on the torque of the feed axis for any other type of feed motion.

These are the options before the change:



These are the options after the change:



Upgrade Note: When upgrading to this version, it is important to remember to restore the dynamic options in low level in order to see this change take effect.

WARNING: Be Careful to Set Proper Torque Limits

WARNING! Do not set the HIGH value to any value above the recommended value - or the Feed Axis gear box or other parts of the carriage or carriage motion system could be damaged by high settings in the Bender Data page. "25%" is typically the maximum recommended value for extended-run. Any higher value may damage the machine and possibly void the warranty.

WARNING! Do not set the LOW value to any value below the recommended value - or the Feed Axis gear box or other parts may run-away due to high-errors. "10%" is typically the minimum recommended value for extended-run. Any lower value may damage the machine and possibly void the warranty.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• Read about Push Bending
• Read about Push Bend Profile Tables