Difference between revisions of "CNC Bender v11-20090126"

From ATTWiki
Jump to: navigation, search
(25px ENHANCE - Adjust General Dynamic Option Name - Feed-Bend Torque Limits)
(25px Warnings)
Line 24: Line 24:
 
<br><br>
 
<br><br>
  
===[[image:Check.jpg|25px]] Warnings ===
+
===[[image:Check.jpg|25px]] WARNING: Be Careful to Set Proper Torque Limits ===
 
<br>
 
<br>
  

Revision as of 20:48, 26 January 2009

Cncbender logo pushbending.png

Operatorstation model.jpg



Check.jpg ENHANCE - Adjust General Dynamic Option Name - Feed-Bend Torque Limits

The Low Level names of dynamic options "Feed Torque Safe High" and "Feed Torque Safe Low" were adjusted for clarification.

The new names include "Feed-Bend" inserted in the beginning to be sure users understand that these values are used by the Processlist Builder to limit the feed axis torque during Feed-Bending only. These values have no effect on the torque of the feed axis for any other type of feed motion.

These are the options before the change:

Cnc torque limit options1.jpg

These are the options after the change:

Cnc torque limit options2.jpg

Upgrade Note: When upgrading to this version, it is important to remember to restore the dynamic options in low level in order to see this change take effect.

Check.jpg WARNING: Be Careful to Set Proper Torque Limits


Gear warning.jpg WARNING!

Do not set the HIGH value to any value above the recommended value - or the Feed Axis gear box or other parts of the carriage or carriage motion system could be damaged by high settings in the Bender Data page.

"25%" is typically the maximum recommended value for extended-run.

Any higher value may damage the machine and possibly void the warranty.


Gear warning.jpg WARNING!

Do not set the LOW value to any value below the recommended value - or the Feed Axis gear box or other parts may run-away due to high-errors.

"10%" is typically the minimum recommended value for extended-run.

Any lower value may damage the machine and possibly void the warranty.

Other Pages