Difference between revisions of "CNC Bender v11-200900915"

From ATTWiki
Jump to: navigation, search
(25px ENHANCED - Pressure Die Advanced Timer Choice)
(25px ENHANCED - Pressure Die Advanced Timer Choice in Processlist Builder)
Line 4: Line 4:
 
__NOTOC__
 
__NOTOC__
  
===[[image:Check.jpg|25px]] ENHANCED - Pressure Die Advanced Timer Choice in Processlist Builder  ===
+
===[[image:Check.jpg|25px]] ENHANCED - Pressure Die Advanced Timer Choice in [[Processlist Builder]] ===
  
The pressure die advance timer choice in the Processlist Builder is now dependent on the Pressure Die Assist setup in the Low Level General Dynamic Options list.
+
The pressure die advance timer choice in the[[ Processlist Builder]] is now dependent on the Pressure Die Assist setup in the Low Level General Dynamic Options list.
 
<br><br>
 
<br><br>
 
[[image:pdamode_follower_noprox.jpg|450px]]
 
[[image:pdamode_follower_noprox.jpg|450px]]

Revision as of 13:30, 15 September 2009

Cncbender logo pushbending.png

Operatorstation model.jpg


Check.jpg ENHANCED - Pressure Die Advanced Timer Choice in Processlist Builder

The pressure die advance timer choice in the Processlist Builder is now dependent on the Pressure Die Assist setup in the Low Level General Dynamic Options list.

Pdamode follower noprox.jpg

For example, if the PDA Mode is set to Follower / No Prox, then the Processlist Builder will switch to use the new PressureDieAdvanceWithTimer Without PDA command like this:

PressureDieAdvanceWithTimer Without PDA = tim2:500, cto:6000

Check.jpg ENHANCED - AutoLoader Timeout is Tied to Robot Timeout

The Robot Timeout value in the Low Level dynamic options is now used to control the AutoLoader timeouts.


Other Pages