Difference between revisions of "CNC Bender v11-200900915"
From ATTWiki
| Line 4: | Line 4: | ||
__NOTOC__ | __NOTOC__ | ||
| − | ===[[image:Check.jpg|25px]] ENHANCED - Pressure Die Advanced Timer Choice === | + | ===[[image:Check.jpg|25px]] ENHANCED - Pressure Die Advanced Timer Choice in Processlist Builder === |
The pressure die advance timer choice in the Processlist Builder is now dependent on the Pressure Die Assist setup in the Low Level General Dynamic Options list. | The pressure die advance timer choice in the Processlist Builder is now dependent on the Pressure Die Assist setup in the Low Level General Dynamic Options list. | ||
Revision as of 13:30, 15 September 2009
ENHANCED - Pressure Die Advanced Timer Choice in Processlist Builder
The pressure die advance timer choice in the Processlist Builder is now dependent on the Pressure Die Assist setup in the Low Level General Dynamic Options list.
For example, if the PDA Mode is set to Follower / No Prox, then the Processlist Builder will switch to use the new PressureDieAdvanceWithTimer Without PDA command like this:
PressureDieAdvanceWithTimer Without PDA = tim2:500, cto:6000
ENHANCED - AutoLoader Timeout is Tied to Robot Timeout
The Robot Timeout value in the Low Level dynamic options is now used to control the AutoLoader timeouts.
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See Cycle Hold
- See Hopper Logic
- See Processlist
- See Secondary Processlist
