CNC Bender v11-20080923

From ATTWiki
Revision as of 04:34, 26 September 2008 by Mcone (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Cncbender logo.jpg

Operatorstation model.jpg

Contents


This is mainly a set of debug changes to CNC Bender.

CHANGES to CNC BENDER

Check.jpg REPAIR - Collision Detection Logic in CNC Processor Repaired for Inputs

Momemtum modicon.jpg

CNC Processor was corrected to examine the second register (or bank) of 16 points on a 32 bit module.

Check.jpg ENHANCED - "Ranger Error" is now changed to "Collision"

CNC Processor now reports a potential "collision" rather than a "ranger error" in the logs. We felt that this is clearer English.

Check.jpg ENHANCED - Relative Bend Arm Behavior Changed

In previous versions, CNC Bender would stop any process that tried to send the bend arm into the negative region.
Bendarm pines 236.jpg

CNC Bender now automatically adjusts the bend arm motion if the operator instructs the axis to go further than 0 (into the negative region) with any controlled motion (including controlled jogs).

Check.jpg REPAIR - PDA GEARED Axis Safe Mode Auto Recovery

Cncbender pda rvg icon large.jpg
A Pressure Die Assist axis now participates in the Safe Mode Motion Auto Recovery when it is geared.

Other Pages