Difference between revisions of "CNC Bender v11-20080923"

From ATTWiki
Jump to: navigation, search
(25px ENHANCEMENT - Relative Bend Arm Behavior)
(25px ENHANCEMENT - "Ranger Error" is now changed to "Collision")
Line 15: Line 15:
  
  
===[[image:Check.jpg|25px]] ENHANCEMENT - "Ranger Error" is now changed to "Collision" ===
+
===[[image:Check.jpg|25px]] ENHANCED - "Ranger Error" is now changed to "Collision" ===
 
<br><br>
 
<br><br>
 
CNC Processor now reports a potential "collision" rather than a "ranger error" in the logs.  We felt that this is clearer English.
 
CNC Processor now reports a potential "collision" rather than a "ranger error" in the logs.  We felt that this is clearer English.
 
<br><br>
 
<br><br>
 
  
 
===[[image:Check.jpg|25px]] ENHANCEMENT - Relative Bend Arm Behavior ===
 
===[[image:Check.jpg|25px]] ENHANCEMENT - Relative Bend Arm Behavior ===

Revision as of 04:13, 26 September 2008

Cncbender logo.jpg

Operatorstation model.jpg

Contents


This is mainly a set of debug changes to CNC Bender.

CHANGES to CNC BENDER

Check.jpg REPAIR - Collision Detection Logic in CNC Processor



CNC Processor was corrected to examine the second register (or bank) of 16 points on a 32 bit module.


Check.jpg ENHANCED - "Ranger Error" is now changed to "Collision"



CNC Processor now reports a potential "collision" rather than a "ranger error" in the logs. We felt that this is clearer English.

Check.jpg ENHANCEMENT - Relative Bend Arm Behavior

In previous versions, CNC Bender would stop any process that tried to send the bend arm into the negative region.

CNC Bender now automatically adjusts the bend arm motion if the operator instructs the axis to go further than 0 (into the negative region) with any controlled motion (including controlled jogs).


Check.jpg REPAIR - PDA Axis Safe Mode Auto Recovery

A Pressure Die Assist axis now participates in the Safe Mode Motion Auto Recovery when it is geared.

Other Pages