Difference between revisions of "CNC Bender v11-20080923"
From ATTWiki
| Line 14: | Line 14: | ||
<br><br> | <br><br> | ||
| + | |||
| + | ===[[image:Check.jpg|25px]] ENHANCEMENT - "Ranger Error" is now changed to "Collision" === | ||
| + | <br><br> | ||
| + | CNC Processor now reports a potential "collision" rather than a "ranger error" in the logs. We felt that this is clearer English. | ||
| + | <br><br> | ||
=Other Pages= | =Other Pages= | ||
*Back to [[CNC Bender]] | *Back to [[CNC Bender]] | ||
*Back to [[CNC Bender Software Updates]] | *Back to [[CNC Bender Software Updates]] | ||
Revision as of 04:07, 26 September 2008
Contents |
This is mainly a set of debug changes to CNC Bender.
CHANGES to CNC BENDER
REPAIR - Collision Detection Logic in CNC Processor
CNC Processor was corrected to examine the second register (or bank) of 16 points on a 32 bit module.
ENHANCEMENT - "Ranger Error" is now changed to "Collision"
CNC Processor now reports a potential "collision" rather than a "ranger error" in the logs. We felt that this is clearer English.
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
