CNC Bender v10-20080329

From ATTWiki
Revision as of 15:12, 29 March 2008 by Mcone (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Cncbender logo.jpg

Operatorstation model.jpg



CHANGES to CNC PROCESSOR

Check.jpg Repair - Command Timeouts are Bypassed During Safe Mode Cycle Hold

This version of CNC Processor will now reset the timeout timer for all commands when in Safe Mode Cycle Hold. This means that CNC Processor will no longer timeout immediately after both types of Cycle Hold.


Check.jpg Change - CNC Processor Saves The Internal Config to a Backup File

In the previous version, CNC Processor would save it's config file to the CNCProcessor.cfg file. This would overwrite any changes made by operators in the Low Level menus of CNC Bender.

So now CNC Processor saves its state to CNCProcessorBackup.cfg. This will allow for a comparison between the CNCProcessor.cfg file and the actual contents of CNC Processor memory when it was shutdown.

Other Pages