Difference between revisions of "CNC Bender v10-20080329"
From ATTWiki
| (3 intermediate revisions by one user not shown) | |||
| Line 11: | Line 11: | ||
This version of CNC Processor will now reset the timeout timer for all commands when in [[Safe Mode Cycle Hold]]. This means that CNC Processor will no longer timeout immediately after both types of [[Cycle Hold]]. | This version of CNC Processor will now reset the timeout timer for all commands when in [[Safe Mode Cycle Hold]]. This means that CNC Processor will no longer timeout immediately after both types of [[Cycle Hold]]. | ||
| + | |||
| + | |||
| + | ===[[image:Check.jpg|25px]] Change - CNC Processor Saves The Internal Config to a Backup File === | ||
| + | |||
| + | In the previous version, CNC Processor would save it's config file to the CNCProcessor.cfg file. This would overwrite any changes made by operators in the Low Level menus of CNC Bender. | ||
| + | <br><br> | ||
| + | So now CNC Processor saves its state to CNCProcessorBackup.cfg. This will allow for a comparison between the CNCProcessor.cfg file and the actual contents of CNC Processor memory when it was shutdown. | ||
| + | |||
| + | ===Other Pages=== | ||
| + | *Back to [[CNC Bender]] | ||
| + | *Back to [[CNC Bender Software Updates]] | ||
Latest revision as of 15:12, 29 March 2008
CHANGES to CNC PROCESSOR
Repair - Command Timeouts are Bypassed During Safe Mode Cycle Hold
This version of CNC Processor will now reset the timeout timer for all commands when in Safe Mode Cycle Hold. This means that CNC Processor will no longer timeout immediately after both types of Cycle Hold.
Change - CNC Processor Saves The Internal Config to a Backup File
In the previous version, CNC Processor would save it's config file to the CNCProcessor.cfg file. This would overwrite any changes made by operators in the Low Level menus of CNC Bender.
So now CNC Processor saves its state to CNCProcessorBackup.cfg. This will allow for a comparison between the CNCProcessor.cfg file and the actual contents of CNC Processor memory when it was shutdown.
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
