Difference between revisions of "CNC Bender v10-20071120"

From ATTWiki
Jump to: navigation, search
(Menu: Incoming Messages)
(Menu: Incoming Messages)
Line 26: Line 26:
  
 
</ul>
 
</ul>
 +
 +
<br><br>
 +
<br><br>
  
 
====Menu: Machine Lube====
 
====Menu: Machine Lube====

Revision as of 16:20, 23 November 2007

Cncbender logo.jpg

Contents




CHANGES to CNC BENDER



Check.jpg Redesigned Processor Menu

The CNC Processor menu is redesigned to include 5 new tab menus.

Cncprocessor tabmenus.jpg

Cncbender cncprocessor.jpg

Menu: Incoming Messages

    The INCOMING MESSAGES menu now allows you to show an extended history log:

    Cncbender cncprocessor historylog.jpg





Menu: Machine Lube

    The new MACHINE LUBE tab has new controls and features: Cncbender cncprocessor machinelube.jpg The machine lube setup is control from the CNCProcessor.cfg file in the c:\cnc\config folder. </table> </ul> </ul>

    Check.jpg Changed a Range Error Message for Clarity

    A range error message was changed by adding the RADIUS CHANGE information to help users find a solution this problem:


    New Settings

    The "Use Pulse or Constant Output" is a new capability</b>

    Immediate Message

    Range Error - According to the RADIUS CHANGE Interference Zone value in the TOOL page the Cross Slide Would Have Collided With The Pressure Die. If this is not the case, then adjust the RADIUS CHANGE Interference Zone value.


    Check.jpg Production Cycle Time Value

    The "Complete Cycle Time" is changed to "Production Cycle Time" and now provides the overall time from part to part.




    Check.jpg New General Dynamic Option - PD Set Pressure

    If this option is enabled, then the PD Set Pressure Output Points are enabled using the new SetPDPressureOutputPoints command.

    PD set Pressure Output Points enable.jpg



    Check.jpg Changed Terminology

    The following terms are changed in CNC Bender user interface:


    ORIGINAL NEW
    In Low Level
    Tangent to Collet Face
    In Low Level
    Machine Length
    In Run Page
    Complete Cycle Time
    In Run Page
    Production Cycle Time





    CHANGES to CNC PROCESSOR

    Check.jpg Optimized for Win2000 or WinXP

    This CNC Processor recognizes the current operating system and optimizes the loop for each operating system.








    How to UPGRADE

    CNC Bender User Interface for ProControl

    If your operator station contains one of the versions listed below, then they can be upgraded through simple self-installation:



    See our CNC Bender Upgrade Policy page for details regarding the charges for the upgrade software.


    Nav down green.pngDownload the setup file by clicking on this link.
    This setup file requires a password to run. Please contact John Esralian for upgrade prices and password information.

    For instructions on how to install the file see: How to Install a CNC Bender Upgrade