CNC Bender LiteControl 10.0.5.9g

From ATTWiki
Revision as of 02:19, 31 May 2008 by Mcone (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Cncbender litcontrol logo.jpg

Operatorstation model.jpg

Contents


This is a minor change to an older version of CNC Bender LiteControl. It is only intended to update customers with older 800 x 600 screen operator stations.

Check.jpg New General Dynamic OPTION: Allow Monitor for Chuck Close Button

The chuck close button could automatically close the chuck at any point during a bend cycle. This could cause a problem for customers that skip the run buttons in hitch feed mode, as the chuck could close at the wrong time during hitch feeding. Customers wanted this prevented, so we've added a General Dynamic Option "Always Monitor for Chuck Close Button" with a default state of DISABLED.

Cncbender litcontrol monitorchuckclose.jpg



If this option is disabled, then CNC Bender will not monitor for the chuck close button unless it is specifically called for in the process list by CNC Processor.

Other Pages