CNCProcessor.cfg

From ATTWiki
Revision as of 20:54, 28 January 2009 by Mcone (Talk | contribs)

Jump to: navigation, search

Contents


What is It?

The CNCProcessor.cfg file exists in the c:\cnc\config folder. It contains setup information for the CNC Processor.

Sections

Each of the sections in the CNCProcessor.cfg is set apart with values in square brackets like this:

[Machine Lube]

Properties for Older Versions of CNC Bender

Example properties for an axis:

[Machine Lube]
Machine Lube Duration=5000
Lube Machine At Bend Count=100
Pulse Machine Lube Pump=1
Watch For Machine Lube Complete Input=0

[CIO]
CIO Name Of Input Clamp Die Close=Input_ClampIsClosed_End
CIO Name Of Input Pressure Die Home=Input_PressureDieIsHome_End
CIO Name Of Input Pressure Die Close=Input_PressureDieIsClosed_End
CIO Name Of Input Carriage Cross Slide Advance=Input_CarriageCrossSlideIsAdvanced_End
CIO Name Of Input Release  Button=Input_Release_Button_End
CIO Name Of Output Release Illuminate=Output_Release_Illuminate
CIO Name Of Boost Bottom Advance=Output_BoostBottom_Advance
CIO Name Of Boost Top Advance=Output_BoostTop_Advance
CIO Name Of Bend Positive=MOVE_BEND_POS_RELATIVE
CIO Name Of Output Machine Lube=Output_MachineLube_Repeat
CIO Name of Input Machine Lube Complete=Input_MachineLubeComplete_End
CIO Name Of Output Bend Head Down1=Output_HeadShiftDown1_Repeat
CIO Name Of Output Bend Head Down2=Output_HeadShiftDown2_Repeat
CIO Name Of Output Bend Head Center1=Output_HeadShiftCenter1_Repeat
CIO Name Of Output Bend Head Center2=Output_HeadShiftCenter2_Repeat
CIO Name Of Output Bend Head Up1=Output_HeadShiftUp1_Repeat
CIO Name Of Output Bend Head Up2=Output_HeadShiftUp2_Repeat


[SOUND]
INIT=cncbender_initialized.wav
AE=all_axes_enabled.wav
AD=all_axes_disabled.wav
WRE=warning_range_error_encountered.wav
CH=cycle_hold.wav
CS=cycle_start.wav
MM=manual_mode.wav
SM=step_mode.wav
AM=auto_mode.wav
SMMF=switch_to_manual_mode_first.wav

[Loop]
Power Off Manual Mode Pause=5
Power On Manual Mode Pause=5
Cycle Hold Pause=5

[Opcode]
Transform 2031 Enabled=0
Transformed 2031=2023

[PRIORITY]
Master Loop Priority=10000


Note that remarks may be added to the file with lines preceded by double forward slashes.

// How long does the machine loop output enable?



Properties Definition

Read about individual properties:

These two properties control the Auto Lube feature:
Machine Lube Duration
Lube Machine At Bend Count