Difference between revisions of "CNCProcessor.cfg"

From ATTWiki
Jump to: navigation, search
(Properties Definition)
(Properties)
Line 10: Line 10:
  
  
===Properties===
+
===Properties for Older Versions of CNC Bender===
  
 
Example properties for an axis:
 
Example properties for an axis:

Revision as of 22:23, 10 April 2008

Contents


What is It?

The CNCProcessor.cfg file exists in the c:\cnc\config folder. It contains setup information for the CNC Processor.

Sections

Each of the sections in the CNCProcessor.cfg is set apart with an axis section label like this:

[Intervals]


Properties for Older Versions of CNC Bender

Example properties for an axis:

[Intervals]

Machine Lube Duration= 5000
Lube Machine At Bend Count= 1000

[CIO]
CIO Name Of Input Clamp Die Close=Input_ClampIsClosed_Begin
CIO Name Of Input Pressure Die Home=Input_PressureDieIsHome_End
CIO Name Of Input Pressure Die Close=Input_PressureDieIsClosed_Begin
CIO Name Of Input Carriage Cross Slide Advance=Input_CarriageCrossSlideIsAdvanced_End
CIO Name Of Input Release  Button= Input_Release_Button_End
CIO Name Of Output Release Illuminate= Output_Release_Illuminate
CIO Name Of Boost Bottom Advance= Output_BoostBottom_Advance
CIO Name Of Boost Top Advance= Output_BoostTop_Advance
CIO Name Of Bend Positive= MOVE_BEND_POS_RELATIVE
CIO Name Of Output Machine Lube=Output_MachineLube_Repeat


[SOUND]
INIT=cncbender_initialized.wav
AE=all_axes_enabled.wav
AD=all_axes_disabled.wav
WRE=warning_range_error_encountered.wav
CH=cycle_hold.wav
CS=cycle_start.wav
MM=manual_mode.wav
SM=step_mode.wav
AM=auto_mode.wav
SMMF=switch_to_manual_mode_first.wav

[PRIORITY]
Master Loop Priority=10000


Note that remarks may be added to the file with lines preceded by double forward slashes.

// How long does the machine loop output enable?



Properties Definition

Read about individual properties:

These two properties control the Auto Lube feature:
Machine Lube Duration
Lube Machine At Bend Count