Benderlink for Pines

From ATTWiki
Revision as of 00:46, 1 May 2008 by Mcone (Talk | contribs)

Jump to: navigation, search
Blinkpines v2 mainscreen.jpg

Blink pines logo.jpg


Contents

About

Benderlink for Pines is software that connects PINES TS2000 controls with Eaton Leonard Vector Laservision measuring centers.


Installs on the TS-2000 Control

Ts-2000.jpg

The software installs directly on the operator station of the Pines TS-2000 controls. It is designed to interact directly with the control. The designer of the TS-2000 included a "Laservision" button that loads and calls to Benderlink for Pines.

Versions

Version 1.x

Blinkpines v1 mainscreen.jpg

Version 1 of Benderlink for Pines communicated with Laservisions using the ATT protocol. The ATT protocol was a special protocol that required customers to purchase and install an upgrade to the Vector Laservision.

Version 2.0

Blinkpines v2 mainscreen.jpg

Version 2 is designed to communicate using the standard Eaton Leonard Velog, EL-2000, and Premier protocol. This protocol is available on every Eaton Leonard measuring center. No upgrade is necessary.


LASERVISION.jpg
PINES bender.jpg