Benderlink for Pines

From ATTWiki
Revision as of 00:45, 1 May 2008 by Mcone (Talk | contribs)

Jump to: navigation, search

Blink pines logo.jpg

LASERVISION.jpg
PINES bender.jpg


Contents

About

Benderlink for Pines is software that connects PINES TS2000 controls with Eaton Leonard Vector Laservision measuring centers.

Blinkpines v2 mainscreen.jpg

Installs on the TS-2000 Control

The software installs directly on the operator station of the Pines TS-2000 controls. It is designed to interact directly with the control. The designer of the TS-2000 included a "Laservision" button that loads and calls to Benderlink for Pines. Ts-2000.jpg

Versions

Version 1.x

Blinkpines v1 mainscreen.jpg

Version 1 of Benderlink for Pines communicated with Laservisions using the ATT protocol. The ATT protocol was a special protocol that required customers to purchase and install an upgrade to the Vector Laservision.

Version 2.0

Blinkpines v2 mainscreen.jpg

Version 2 is designed to communicate using the standard Eaton Leonard Velog, EL-2000, and Premier protocol. This protocol is available on every Eaton Leonard measuring center. No upgrade is necessary.