Difference between revisions of "Benderlink for Pines"

From ATTWiki
Jump to: navigation, search
(Versions)
(Version 1.0)
Line 18: Line 18:
  
 
Version 1 of Benderlink for Pines communicated with Laservisions using the ATT protocol.  The ATT protocol was a special protocol that required customers to purchase and install an upgrade to the Vector Laservision.
 
Version 1 of Benderlink for Pines communicated with Laservisions using the ATT protocol.  The ATT protocol was a special protocol that required customers to purchase and install an upgrade to the Vector Laservision.
 +
<br><br>
 
[[image:Blinkpines_v1_mainscreen.jpg|200px]]
 
[[image:Blinkpines_v1_mainscreen.jpg|200px]]
 
  
 
==Version 2.0==
 
==Version 2.0==

Revision as of 00:48, 1 May 2008

Blinkpines v2 mainscreen.jpg

Blink pines logo.jpg


Contents

About

Benderlink for Pines is software that connects PINES TS2000 controls with Eaton Leonard Vector Laservision measuring centers.


Installs on the TS-2000 Control

The software installs directly on the operator station of the Pines TS-2000 controls. It is designed to interact directly with the control. The designer of the TS-2000 included a "Laservision" button that loads and calls to Benderlink for Pines.

Ts-2000.jpg

Versions

Version 1.0

Version 1 of Benderlink for Pines communicated with Laservisions using the ATT protocol. The ATT protocol was a special protocol that required customers to purchase and install an upgrade to the Vector Laservision.

Blinkpines v1 mainscreen.jpg

Version 2.0

Version 2 is designed to communicate using the standard Eaton Leonard Velog, EL-2000, and Premier protocol. This protocol is available on every Eaton Leonard measuring center. No upgrade is necessary. Blinkpines v2 mainscreen.jpg


LASERVISION.jpg
PINES bender.jpg