Difference between revisions of "Benderlink for Pines"

From ATTWiki
Jump to: navigation, search
(About)
(Installs on the TS-2000 Control)
Line 10: Line 10:
  
 
=Installs on the TS-2000 Control=
 
=Installs on the TS-2000 Control=
 +
[[image:Ts-2000.jpg|100px|left]]
 
The software installs directly on the operator station of the Pines TS-2000 controls.  It is designed to interact directly with the control.  The designer of the TS-2000 included a "Laservision" button that loads and calls to Benderlink for Pines.
 
The software installs directly on the operator station of the Pines TS-2000 controls.  It is designed to interact directly with the control.  The designer of the TS-2000 included a "Laservision" button that loads and calls to Benderlink for Pines.
[[image:Ts-2000.jpg|100px]]
 
  
 
=Versions=
 
=Versions=

Revision as of 00:45, 1 May 2008

Blink pines logo.jpg

LASERVISION.jpg
PINES bender.jpg


Contents

About

Benderlink for Pines is software that connects PINES TS2000 controls with Eaton Leonard Vector Laservision measuring centers.

Blinkpines v2 mainscreen.jpg

Installs on the TS-2000 Control

Ts-2000.jpg

The software installs directly on the operator station of the Pines TS-2000 controls. It is designed to interact directly with the control. The designer of the TS-2000 included a "Laservision" button that loads and calls to Benderlink for Pines.

Versions

Version 1.x

Blinkpines v1 mainscreen.jpg

Version 1 of Benderlink for Pines communicated with Laservisions using the ATT protocol. The ATT protocol was a special protocol that required customers to purchase and install an upgrade to the Vector Laservision.

Version 2.0

Blinkpines v2 mainscreen.jpg

Version 2 is designed to communicate using the standard Eaton Leonard Velog, EL-2000, and Premier protocol. This protocol is available on every Eaton Leonard measuring center. No upgrade is necessary.