Ball Probe Setup

From ATTWiki
Revision as of 17:33, 4 September 2015 by Mcone (Talk | contribs)

Jump to: navigation, search

Vtube-laser logo 1.96.png

Vtl screen hd scanner without logo.png



About the Default Ball Probe Setup

The default ball probe setup is always controlled by the FARO drivers and dialogs. These are windows that can be loaded from VTube-LASER while it is connected to the arm. To change the default ball probe, you will need to access the FARO dialog and choose the correct probe.

You must be connected to a FARO arm to perform these steps.

STEP 1

In VTube-LASER click on the Arm Utilities button in the Arm tab inside the Measure Setup menu.

Vtube-laser v2.2 measuresetup arm armutilities.png

STEP 2

Press Probe Setup and Calibration.

Vtube-laser v2.2 armutilities dialog press probesetup and calibration.png

STEP 3

Select the correct ball probe then press OK.

This step will cause the FARO driver to report back to VTube the new probe. The FARO driver should always remember the last ball probe that you set to "Current Probe" in the pulldown box. This is true even if you shutdown VTube-LASER and the FARO arm.

Vtube-laser v2.2 faro compensation menu.png

STEP 4

Press the Close button in the FARO Arm Utilities window.

Vtube-laser v2.2 armutilities dialog press close.png

STEP 5

Observe that the new ball probe selection will appear in the Arm grid.

Vtube-laser 2.2 measuresetup menu 6mmball.png


Other Pages