Difference between revisions of "Ball Probe Setup"

From ATTWiki
Jump to: navigation, search
(About the Default Ball Probe Setup)
(STEP 2)
Line 34: Line 34:
 
<td width=300>
 
<td width=300>
 
===STEP 2===
 
===STEP 2===
Change the values in VTube to whatever you want them be when you perform a clear. Be sure that no tube data exits in this state, or VTube will clear the data to preset values with a tube.  (Of course, you can do this, if you really meant to.)</td>
+
Press Probe Setup and Calibration.</td>
 
<td>
 
<td>
[[image:vtube-step_v2.2_cleared.png|400px]]
+
[[image:vtube-laser_v2.2_armutilities_dialog_press_probesetup_and_calibration.png|400px]]
 
</td>
 
</td>
 
</tr>
 
</tr>
 
<tr>
 
<tr>
 
<td width=300>
 
<td width=300>
 +
 
===STEP 3===
 
===STEP 3===
 
Press the System Options button.</td>
 
Press the System Options button.</td>

Revision as of 17:15, 4 September 2015

Vtube-laser logo 1.96.png

Vtl screen hd scanner without logo.png



About the Default Ball Probe Setup

The default ball probe setup is always controlled by the FARO dialogs. These are windows that can be loaded from VTube-LASER while it is connected to the arm. To change the default ball probe, you will need to access the FARO dialog and choose the correct probe.

You must be connected to a FARO arm to perform these steps.

STEP 1

In VTube-LASER click on the Arm Utilities button in the Arm tab inside the Measure Setup menu.

Vtube-laser v2.2 measuresetup arm armutilities.png

STEP 2

Press Probe Setup and Calibration.

Vtube-laser v2.2 armutilities dialog press probesetup and calibration.png

STEP 3

Press the System Options button.

Vtube-STEP v2.2 toolbar sys.png

STEP 4

Press the Project Setup tab, and then press the Set Project Default State button.

Vtube v2.2 projecttab saveprojectdefault.png

STEP 5

Exit the System Options menu. VTube will now clear to the new settings.

Vtube v2.2 systemoptions closemenu.png


Other Pages