Difference between revisions of "20210603 HEXAGON Arm - VTube-LASER crashes with Class Not Registered Error at Load"
From ATTWiki
(Created page with "Back to VTube-LASER ==CUSTOMER ARM MODEL== *HEXAGON Arm *Model RA8 *Scanner RS6 ==OPERATOR ISSUE== VTube-LASER crashes at load with this message:<br><br> image:vtl_3_...") |
|||
Line 12: | Line 12: | ||
− | ==OUR DISCOVERY== | + | ==OUR DISCOVERY PROCESS== |
+ | * I logged in using ConnectWise Control. The computer system was not using the FARO arm, so the error could not be coming from the FARO driver not being installed (which would be one possibility). | ||
− | + | * The latest build of VTube-LASER was being used (v3 build 516). | |
− | + | ||
+ | * I decided that we should then start with reinstalling VTube-LASER. | ||
+ | |||
+ | ==OUR SOLUTION== | ||
+ | So, we ran the VTL installation again. We ensured that it was running in Adminstrator mode. | ||
==RESULT== | ==RESULT== | ||
VTube-LASER loads fine. | VTube-LASER loads fine. |
Revision as of 13:52, 3 June 2021
Back to VTube-LASER
Contents |
CUSTOMER ARM MODEL
- HEXAGON Arm
- Model RA8
- Scanner RS6
OPERATOR ISSUE
VTube-LASER crashes at load with this message:
OUR DISCOVERY PROCESS
- I logged in using ConnectWise Control. The computer system was not using the FARO arm, so the error could not be coming from the FARO driver not being installed (which would be one possibility).
- The latest build of VTube-LASER was being used (v3 build 516).
- I decided that we should then start with reinstalling VTube-LASER.
OUR SOLUTION
So, we ran the VTL installation again. We ensured that it was running in Adminstrator mode.
RESULT
VTube-LASER loads fine.