VTube-LASER v1.59

Revision 1.59 Back to VTube-LASER

NEW: Help Reference for LASER Mode

Now VTube-LASER has its own help reference.

REPAIR: Mix ball probe and laser measurement

Using ball probe measurements on the end scans and and laser measurements in the cylinder straights now offsets the ball radius point properly in every case.

ENHANCEMENT- Part Name is Used as Filename When Part Name Changes

In previous versions, the part name was used as the filename only if the previous filename was empty. Now - when the part name changes, the part name is used as the initial filename in the Save dialog.

Changes to VTube-STEP

See VTube-STEP v1.59 for changes to the STEP mode in this version.

Issues with this version fixed in next version

No known issues

Other Pages

• Back to VTube-LASER