CNC Bender v12-20100820
|
|
NEW - Servo Status Grid Now Always Visible on Main Screen
|
The status of up to 20 servo axes are now displayed at all times in a small grid on the main page. Whenever the states change, the grid cells color changes to either grey, green, or red. |
|
NEW - BIG Messages
|
For important events, CNC Bender now displays large messages for short periods of time. This lets operators clearly know what the control needs them to do next.
|
|
NEW - Press ENABLE to Jog
|
Some of our OEM Partner controls require that the operator press the ENABLE button to Jog. CNC Bender can be set in Low Level to require an ENABLE button for all jogging. If the ENABLE button is not pressed when the joy stick is moved, then the "Press ENABLE to Jog" message appears on the screen.
|
|
CHANGES - CNC Processor Configuration File
|
The following additions have been made to the configuration file:
|
[Smart Inspect Logging] Enabled=0 Logging Method=TCPIP Filename=c:\cnc\logs\cncprocessor.sil TCPIP Address=192.168.0.190 [Loop] Main Loop Interval=0.100 Background Read Servo Loop Interval=0.100 |
|
Thee items on the right can be removed from the configuration file. They are no longer used in CNC Processor. |
Remove these from the CNCProcessor.cfg file: [Loop] Power Off Manual Mode Pause=250 Power On Manual Mode Pause=250 Cycle Hold Pause=100 [PRIORITY] Master Loop Priority=10000 |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
