Benderlink for FARO 1.5

New - Reverse Bend Data Features

There are times when the nominal tube data may show the opposite point and bend order than used for bending. During communications, the bend order needs to be the same - so this allows operators to adjust the order of the bend data to fit both the CAM2 measure and the bend data setup in the bender control.

New - Automatically Reverse Incoming Data Checkbox

Benderlink can now automatically reverse all incoming FARO CAM2 data if this new feature is enabled.

New - Reverse Bender Data or Un-reverse Bender Data

Benderlink can now reverse the FARO CAM2 data after it is imported. The Reverse Bend Data button acts as a toggle for reversing and un-reversing the bend data. The new "Data Original" or "Data Reverse" flag also clearly shows if the data has been reversed.

New - 64 Bit Compatibility

This Benderlink is now compatible with 64 bit Windows

New - AddisonMckee Control Compatibility

Benderlink for FARO now has extended Supravision network capabilities for AddisonMckee Mark IV and Mark V controls.

Fix - User Interface Memory Leaks Repaired

Benderlink caused resource failures in previous versions. This has been resolved with this version of Benderlink for FARO.

New - Screen Snap

Benderlink now has screen snap capability. As you move Benderlink toward the screen edge, the window will snap to the edge of the screen.

Other Pages

• Back to the Benderlink for FARO page