CNC Bender v12-20100903
NEW - CYCLE HOLD in Custom Commands and in TEACH Mode
Now CYCLE HOLD anywhere inside a CUSTOM COMMAND either manually entered or taught during TEACH MODE. |
|
ENHANCED - ENABLE Button for STEP and AUTO Modes
The "REQUIRE ENABLE BUTTON" feature, when active, now also monitors for a switch to AUTO or STEP modes from MANUAL mode |
|
ENHANCED - Vertical Head Shift Tolerance Added
The vertical head shift tolerance allows us to skip motion when an axis is close enough to the final position. |
|
ENHANCED - Added CNC Processor Automatic High Pressure Handling
CNC Processor now uses the CIO Name Cross Reference in the Low Level menu to automatically set the high pressure under these two special circumstances:
|
|
ENHANCED - CNC Processor Soft EOT with New Ramp-Down for JOG Speeds
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands