Scanning on a NEWPORT type table
From ATTWiki
|
NEWPORT Tables
Scanning on NEWPORT tables is possible with the FARO scanner system, but care must be taken because of the high reflectivity of the surfaces in the drilled and tapped holes. | |
Scanning Example
The image on right shows an example of scanning a tube on a Newport table. | |
Potential For Outliers At Normal Relfective Surfaces
View the angle of the scanner in the image in the preceding section. |
|
This is the image of the real-time scanned points in the FARO Laser Line Probe scanner setup screen. |
|
The Impact on Cylinder Calculations
If VTube uses these outliers to calculate the diameter, then often the cylinder fit math will fail to find a centerline - and VTube will ask you to remeasure the straight where the problem is occuring. | |
Other Pages
- Back to the VTube-STEP page
- Back to the VTube-LASER page