Difference between revisions of "Benderlink for Pines"

From ATTWiki
Jump to: navigation, search
(Installs on the TS-2000 Control)
(Installs on the TS-2000 Control)
Line 8: Line 8:
  
  
=Installs on the TS-2000 Control=
+
=TS-2000 Control to Vector 1 Laservision=
  
 
[[Image:EL Laservision Tube Data Center.jpg|right]]
 
[[Image:EL Laservision Tube Data Center.jpg|right]]

Revision as of 00:52, 1 May 2008

Blinkpines v2 mainscreen.jpg

Blink pines logo.jpg


Contents

About

Benderlink for Pines is software that connects PINES TS2000 controls with Eaton Leonard Vector Laservision measuring centers.


TS-2000 Control to Vector 1 Laservision

EL Laservision Tube Data Center.jpg

The software installs directly on the operator station of the Pines TS-2000 controls. It is designed to interact directly with the control. The designer of the TS-2000 included a "Laservision" button that loads and calls to Benderlink for Pines.

Ts-2000.jpg

Versions

Version 1.0

Version 1 of Benderlink for Pines communicated with Laservisions using the ATT protocol. The ATT protocol was a special protocol that required customers to purchase and install an upgrade to the Vector Laservision.

Blinkpines v1 mainscreen.jpg

Version 2.0

Version 2 is designed to communicate using the standard Eaton Leonard Velog, EL-2000, and Premier protocol. This protocol is available on every Eaton Leonard measuring center. No upgrade is necessary.

Blinkpines v2 mainscreen.jpg


LASERVISION.jpg
PINES bender.jpg