Difference between revisions of "VTube-LASER v2.9.5"
(→25pxFIX - REPAIRED LOSS OF ORIGINAL ORIENTATION) |
(→25pxFIX - REPAIRED LOSS OF ORIGINAL ORIENTATION) |
||
Line 100: | Line 100: | ||
− | ==[[image:Check.jpg|25px]]FIX - REPAIRED LOSS OF ORIGINAL ORIENTATION== | + | ==[[image:Check.jpg|25px]]FIX - REPAIRED LOSS OF ORIGINAL ORIENTATION DURING REVERSE CALC== |
<table cellpadding=10 width=800> | <table cellpadding=10 width=800> | ||
Line 119: | Line 119: | ||
</table> | </table> | ||
<br><br> | <br><br> | ||
− | |||
− | |||
− | |||
==[[image:Check.jpg|25px]]FIX - BUILD TO SOLIDWORKS ASSEMBLY== | ==[[image:Check.jpg|25px]]FIX - BUILD TO SOLIDWORKS ASSEMBLY== |
Revision as of 13:57, 28 February 2018
Revision 2.9.5Release Date: February 19, 2018
|
ENHANCED - FASTER USER INTERFACE
VTube is now faster due to some important changes to the user interface. |
FIX - SOLID MODEL IMAGE PRINT IN REPORTS
VTube is designed to handle multiple displays. |
NEW - SEPARATE PERSPECTIVE MODES FOR STEP and LASER WINDOWS
In previous versions, there was only a single Perspective Mode switch. |
NEW - REQUEST REVERSE CALC WHEN EXITING THE LRA GRIDS
When you edit the data in the LRA grid, VTube-LASER now assumes that you probably mean to perform a reverse calc. |
FIX - REPAIRED LOSS OF ORIGINAL ORIENTATION DURING REVERSE CALC
VTube always attempts to keep the original XYZ orientation when you perform a Reverse Calc from LRA. |
FIX - BUILD TO SOLIDWORKS ASSEMBLY
VTube would incorrectly build single tubes to a SOLIDWORKS assembly. |
Other Pages
- See VTube-LASER Addata ZModem Communications Protocol for more information.
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature