Difference between revisions of "VTube-LASER v2.9.5"

From ATTWiki
Jump to: navigation, search
(25pxNEW - REQUEST REVERSE CALC WHEN EXITING THE LRA GRIDS)
(25pxFIX - SOLID MODEL IMAGE PRINT IN REPORTS)
Line 46: Line 46:
  
 
<td width=400>
 
<td width=400>
VTube handles multiple displays.<br><br>
+
VTube is designed to handle multiple displays.<br><br>
 
We discovered that, for windows arrangements where the Windows Desktop is not on the far left monitor, VTube might not print the graphics image properly in reports.<br><br>This has been fixed in this version.
 
We discovered that, for windows arrangements where the Windows Desktop is not on the far left monitor, VTube might not print the graphics image properly in reports.<br><br>This has been fixed in this version.
 
</td>
 
</td>
Line 57: Line 57:
 
</table>
 
</table>
 
<br><br>
 
<br><br>
 
  
 
==[[image:Check.jpg|25px]]NEW - SEPARATE PERSPECTIVE MODES FOR STEP and LASER WINDOWS==
 
==[[image:Check.jpg|25px]]NEW - SEPARATE PERSPECTIVE MODES FOR STEP and LASER WINDOWS==

Revision as of 02:02, 28 February 2018

Vtube-laser logo 1.96.png


Revision 2.9.5

Release Date: February 19, 2018
Build:


Vtube-laser v2.7 screenshot.png

Contents


Check.jpgENHANCED- FASTER USER INTERFACE

VTube is now faster due to some important changes to the user interface.



Check.jpgFIX - SOLID MODEL IMAGE PRINT IN REPORTS

VTube is designed to handle multiple displays.

We discovered that, for windows arrangements where the Windows Desktop is not on the far left monitor, VTube might not print the graphics image properly in reports.

This has been fixed in this version.

Vtl report header.png



Check.jpgNEW - SEPARATE PERSPECTIVE MODES FOR STEP and LASER WINDOWS

In previous versions, there was only a single Perspective Mode switch.

In this version, there is a separate Perspective Mode switch for STEP and LASER windows.

Vtl 2.9.5 perspective.png
Vts 2.9.5 perspective.png




Check.jpgNEW - REQUEST REVERSE CALC WHEN EXITING THE LRA GRIDS

When you edit the data in the LRA grid, VTube-LASER now assumes that you probably mean to perform a reverse calc.

If you exit the grid without a reverse calc, then it will immediately ask if you intended to perform a Reverse Calc - and allow you to choose to calculate the XYZ data.

This is active in both the MASTER and the MEASURED LRA grids.

Vtl 2.9.5 request reverse calc.png



Other Pages