Difference between revisions of "How to Switch the OD Mesh On/Off"
From ATTWiki
(→Switch Between Surface and Outline Quickly) |
(→Switch Between Surface and Outline Quickly) |
||
| Line 60: | Line 60: | ||
<table> | <table> | ||
<tr> | <tr> | ||
| − | <td width="200"> | + | <td valign=top width="200"> |
You can switch between surface and outline display quickly by pressing on the right toolbar button with the surface mesh. | You can switch between surface and outline display quickly by pressing on the right toolbar button with the surface mesh. | ||
</td> | </td> | ||
Revision as of 14:54, 8 September 2012
Contents |
Entities Described
The OD Mesh can be composed of two types of entities - either WIRE or SURFACE. Either can be switched on or off independently in TubeCAD. This page describes ways to control them.
Switch Straights Wire
|
Switch the straights WIRE mesh off in the straights by using the Primary Views>3D>Straights wire>On/Off |
|
Switch Arcs Wire
|
Switch the arcs WIRE mesh off in the straights by using the Primary Views>3D>Arcs wire>On/Off |
|
Switch Straights Faces
|
Switch the straights surface mesh off in the straights by using the Primary Views>3D>Straights faces>On/Off |
|
Switch Arcs Wire
|
Switch the arcs surface mesh off in the straights by using the Primary Views>3D>Arcs faces>On/Off |
|
Switch Between Surface and Outline Quickly
|
You can switch between surface and outline display quickly by pressing on the right toolbar button with the surface mesh. |
|
Other Pages
Go back to TubeCAD Pro
