Difference between revisions of "CNC Bender v12-20120622"
From ATTWiki
| Line 30: | Line 30: | ||
| − | ===[[image:Check.jpg|25px]] Repair - Robot Clear Bit=== | + | ===[[image:Check.jpg|25px]] Repair - Robot Clear Bit Can Be High or Low=== |
<table cellpadding=10> | <table cellpadding=10> | ||
Revision as of 15:02, 22 June 2012
v12-20111229
|
|
Repair - Recovery Mode Rotate Spin 180
|
The ROTATE axis could incorrectly rotate 360 degrees when recovering from safety mat activation under rare circumstances of the rotate drifting way from zero. This has been fixed.
|
Repair - Robot Clear Bit Can Be High or Low
|
The Robot Clear bit always assumed that the TRUE signal was bit high. But some machines assume the opposite. This has been fixed.
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
