Difference between revisions of "CNC Bender v12-20120517"
From ATTWiki
| Line 13: | Line 13: | ||
</table> | </table> | ||
__NOTOC__ | __NOTOC__ | ||
| − | ===[[image:Check.jpg|25px]] Repaired Feature - Part Counter Boxes in Run Page === | + | ===[[image:Check.jpg|25px]] New Feature - PDA Return in Test Bend Menu=== |
| + | |||
| + | <table cellpadding=10> | ||
| + | <tr valign=top> | ||
| + | <td width=400> | ||
| + | You can now return the PDA in the Test Bend menu after a bend is complete. | ||
| + | </td> | ||
| + | |||
| + | <td width=300> | ||
| + | |||
| + | |||
| + | </td> | ||
| + | |||
| + | </tr> | ||
| + | </table> | ||
| + | |||
| + | ===[[image:Check.jpg|25px]] Repaired Feature - Fix to Part Counter Boxes in Run Page === | ||
<table cellpadding=10> | <table cellpadding=10> | ||
Revision as of 19:22, 16 May 2012
v12-20111229
|
|
New Feature - PDA Return in Test Bend Menu
|
You can now return the PDA in the Test Bend menu after a bend is complete. |
|
Repaired Feature - Fix to Part Counter Boxes in Run Page
|
The counter values would not always enable in the Run Page. This has been repaired. |
Enhanced Feature - Part Name is Now Always Trimmed
|
Preceding and trailing spaces cause problems because they are hard to detect. The part name is now always trimmed when the operator includes preceding or trailing spaces. |
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
