Difference between revisions of "CNC Bender v12-20120517"
From ATTWiki
| Line 22: | Line 22: | ||
<td width=300> | <td width=300> | ||
| − | |||
| − | |||
</td> | </td> | ||
| − | |||
</tr> | </tr> | ||
</table> | </table> | ||
| − | |||
===[[image:Check.jpg|25px]] Enhanced Feature - Part Name is Now Always Trimmed === | ===[[image:Check.jpg|25px]] Enhanced Feature - Part Name is Now Always Trimmed === | ||
Revision as of 17:43, 16 May 2012
v12-20111229
|
|
Repaired Feature - Part Counter Boxes in Run Page
|
The counter values would not always enable in the Run Page. This has been repaired. |
Enhanced Feature - Part Name is Now Always Trimmed
|
Preceding and trailing spaces cause problems because they are hard to detect. The part name is now always trimmed when the operator includes preceding or trailing spaces. |
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
