Difference between revisions of "VTube-LASER v1.75"
| Line 52: | Line 52: | ||
<td width=300> | <td width=300> | ||
[[image:LongAndShortCylinderFitSetup.jpg|300px]] | [[image:LongAndShortCylinderFitSetup.jpg|300px]] | ||
| + | </td> | ||
| + | </tr> | ||
| + | </table> | ||
| + | |||
| + | |||
| + | ===[[image:Check.jpg|25px]] NEW: Cylinder Fit Radius Deviation Check=== | ||
| + | |||
| + | <table cellpadding=10> | ||
| + | <tr valign=top> | ||
| + | <td width=300> | ||
| + | VTube now checks to be sure that all point clouds used in the diameter calculation all fall within a reasonable tolerance for distance from the calculated centerline. | ||
| + | <br><br> | ||
| + | </td> | ||
| + | <td width=300> | ||
| + | [[image:CylindefFitRadiusDeviationCheck.jpg|300px]] | ||
</td> | </td> | ||
</tr> | </tr> | ||
Revision as of 21:02, 27 January 2012
|
Revision 1.75Back to VTube-LASER |
|
Contents |
ENHANCED: Split Bend Logic and Display
|
After extensive Gage R&R tests, the Split Bend logic is completely rewritten and is more accurate and robust than the original logic.
|
|
ENHANCED: Scanner Setup Saved with Project File
|
This version addresses issues with the new Scanner Setup in v1.74. |
NEW: Separate Cylinder Fit Tolerances for LONG and SHORT Cylinders
|
VTube now has a second set of tolerances for shorter straights. This allows for looser tolerances on shorter straights without producing an error message.
|
|
NEW: Cylinder Fit Radius Deviation Check
|
VTube now checks to be sure that all point clouds used in the diameter calculation all fall within a reasonable tolerance for distance from the calculated centerline.
|
|
ENHANCED: End Scan Qualification Logic
|
The end scan qualification logic was improved to work more often.
The end scans can now be inside the cylinder scans.
|
Other Changes
Other Pages
- Back to VTube-LASER
