Difference between revisions of "CNC Bender v12-20111229"
From ATTWiki
| Line 20: | Line 20: | ||
* The pressure die interference logic would stop the bending with a collision message if a Feed-Bend would take the chuck into the pressure die zone and the PDA was a servo axis. | * The pressure die interference logic would stop the bending with a collision message if a Feed-Bend would take the chuck into the pressure die zone and the PDA was a servo axis. | ||
<br> | <br> | ||
| − | * | + | * Now if the PDA is a servo axis, then the potential for collision is ignored. This will assume that the pressure die is moving forward. |
</td> | </td> | ||
| Line 31: | Line 31: | ||
</tr> | </tr> | ||
</table> | </table> | ||
| − | |||
| − | |||
=Other Pages= | =Other Pages= | ||
Revision as of 18:03, 29 December 2011
v12-20111229
|
|
REPAIR - Pressure Die Interference Zone Collision Message
|
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
