v12-20110525

• Back to CNC Bender Software Updates

• Chuck Close/Open Skip in Post Bend - for special teach mode unloading
  
  
• Processor checks for special internal command in processlists - which is required even in custom processlists:
  
  [BEGIN RUN AGAIN]
  
  
• Allow mandrel to advance in MANUAL page even if clamp or pressure die are closed.

• CNC Bender can now be loaded from the Start Menu at Windows boot without failing to find the hardware key. So now, when the computer is booted, CNC Bender can be made to automatically startup.
  
  

• The default mode index for dynamic options is now always set to the first item when in the toolbox. Previous versions would never control this index value - causing unpredictable value set.
  
  

• Previous / Next buttons are added to quickly move between COMDEF files. No more open dialog is needed!
  
  
• The buttons use the COMDEF File List in the previous tab to quickly locate the next or previous file to load.
  
  
• When pressing one of the two buttons, if there are no names in the COMDEF File List, then COMDEF Editor will load the list with the current COMDEF filenames.
  
  
• Moving from one COMDEF to the next will NOT save the data to the COMDEF files if changes are made. This allows for quick moving from one COMDEF to the next without making any changes.
  
  
• The COMDEF filenames in the filename list are now always sorted.
  
  
• The CIO list to the left will now always sorted.