Difference between revisions of "CNC Bender v12-20110525"
From ATTWiki
| Line 23: | Line 23: | ||
<td width=400> | <td width=400> | ||
* Chuck Close/Open Skip in Post Bend - for special teach mode unloading<br><br> | * Chuck Close/Open Skip in Post Bend - for special teach mode unloading<br><br> | ||
| − | * Processor checks for special internal command in processlists - which is required even in custom processlists: | + | * Processor checks for special internal command in processlists - which is required even in custom processlists:<br><br> |
* Allow mandrel to advance in MANUAL page even if clamp or pressure die are closed. | * Allow mandrel to advance in MANUAL page even if clamp or pressure die are closed. | ||
</td> | </td> | ||
<td> | <td> | ||
| + | '''[BEGIN RUN AGAIN]''' | ||
</td> | </td> | ||
| Line 33: | Line 34: | ||
</table> | </table> | ||
<br><br> | <br><br> | ||
| − | |||
| − | |||
=Other Pages= | =Other Pages= | ||
Revision as of 02:35, 26 May 2011
v12-20110525
|
|
ENHANCED - Changes to Logic
|
[BEGIN RUN AGAIN] |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
