CNC Bender has a new splash screen

A new timer is added to CNC Processor to regulate the response to joystick-type jog motion. This allows for steady jog motion no matter what other process the processor performing.

The default jog speeds for each axis are now set inside the main.axislist configuration file.

The new property name is Default Jog Speed=

See the screen image on the right of the new property in main.axislist file.

The speeds are reset to default:

1. When Processor runs the Init Axis processlist
2. When Processor senses a change between operation modes (manual, step, auto)
3. When exiting the Custom Command Editor

Each axis has its own Default Jog Speed property.

How the values are handled:

• If the default jog speed property and value are not present or the property name is misspelled in the main.axislist file for any axis, then the value defaults to "20" inside CNC Processor.
• If a default jog speed is negative, it is reset to the positive value.
• If a default jog speed exceeds the maximum speed for an axis, then it is reset to the maximum speed.

It is no longer possible to move two axes at the same time when the joystick feature is enabled in the Custom Command Editor

The SetDefaultJogSpeeds is now no longer needed in Init Axis processlist. If it is included, then it will be overridden by CNC Processor based on the axis configuration.