Difference between revisions of "CNC Bender v12-20100707"
From ATTWiki
| Line 19: | Line 19: | ||
Now it is applied to all the output modules throughout the entire system.</td> | Now it is applied to all the output modules throughout the entire system.</td> | ||
<td> | <td> | ||
| − | [[image: | + | [[image:modicon_on_din.jpg|250px]]<br> |
</td> | </td> | ||
</tr> | </tr> | ||
Revision as of 00:55, 8 July 2010
|
|
ENHANCED - All Output Modules Now Use Extended Sustain Time
|
The sustain time is setup in the Processor tab of the low level menu, and was previously applied only to the first output module. |
|
</table>
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
