Difference between revisions of "CNC Bender v11-20091229"

From ATTWiki
Jump to: navigation, search
(→‎25px ENHANCE- Updates to CNC Processor to improve motion command logic)
(→‎25px ENHANCE- Updates to CNC Processor to improve motion command logic)
Line 36: Line 36:
 
<td width=300>
 
<td width=300>
 
[[image:bendarm_blur_vb150.jpg|200px]]
 
[[image:bendarm_blur_vb150.jpg|200px]]
 +
</td>
 +
</tr>
 +
 +
</table>
 +
 +
<br><br>
 +
 +
 +
===[[image:Check.jpg|25px]] CHANGE- PreBend Rotate to Start Angle User-Interface Change===
 +
<table>
 +
<tr valign=top>
 +
<td width=300>
 +
* The PreBend ROTATE TO START ANGLE feature is now only available in the PreBend Dynamic Options list<br><br>
 +
* This reduces confusion so that the operator knows that the feature is available in a single location.<br><br>
 +
</td>
 +
 +
<td width=300>
 +
[[image:rotatetostart_dynamicoption.jpg|200px]]
 
</td>
 
</td>
 
</tr>
 
</tr>

Revision as of 22:05, 30 December 2009

Cncbender logo pushbending.png

Type of Upgrade: Optimization

The changes in this version are designed to make CNC Bender more accurate and run faster.

Operatorstation model.jpg

Contents


Check.jpg ENHANCE- Updates to CNC Processor to improve motion command logic

  • There were circumstances were incremental motion commands could be issued twice when only one command was necessary.

  • This version of CNC Bender removes the potential for double calls to incremental motion commands

Bendarm blur vb150.jpg




Check.jpg CHANGE- PreBend Rotate to Start Angle User-Interface Change

  • The PreBend ROTATE TO START ANGLE feature is now only available in the PreBend Dynamic Options list

  • This reduces confusion so that the operator knows that the feature is available in a single location.

Rotatetostart dynamicoption.jpg



Check.jpg NEW - Tube Mandrel Check and Destroyer Feature

  • CNC Bender can now automatically check for the existence of a broken mandrel after a mandrel extraction.

  • If the mandrel is broken, then CNC Bender process list logic requires the operator to place the tube in a tube destroyer to crush the tube to prevent it from being used in other machinery in the cell.

Tubedestroyer.jpg

Mandrelcheck actuator.jpg



Other Pages

Retrieved from "http://www.advancedtubular.wiki/index.php?title=CNC_Bender_v11-20091229&oldid=13031"