Difference between revisions of "VTube-LASER v2.9.5"
(→25pxFIX - BUILD TO SOLIDWORKS ASSEMBLY) |
(→25pxFIX - BUILD TO SOLIDWORKS ASSEMBLY) |
||
Line 127: | Line 127: | ||
<td width=400> | <td width=400> | ||
VTube would incorrectly build a single tube to both a single part drawing and a SOLIDWORKS ASSEMBLY.<br><br>Since VTube is building a single tube in SOLIDWORKS the best action is to always build a single part drawing.<br><br> | VTube would incorrectly build a single tube to both a single part drawing and a SOLIDWORKS ASSEMBLY.<br><br>Since VTube is building a single tube in SOLIDWORKS the best action is to always build a single part drawing.<br><br> | ||
− | The build logic has been fixed in this version. | + | The build logic has been fixed in this version.<br><br> |
+ | If there are multiple parts in VTube, then VTube will still allow you to choose between building all the parts into one drawing, or building all the parts into a SOLIDWORKS assembly. | ||
</td> | </td> | ||
Revision as of 14:03, 28 February 2018
Revision 2.9.5Release Date: February 19, 2018
|
ENHANCED - FASTER USER INTERFACE
VTube is now faster due to some important changes to the user interface. |
FIX - SOLID MODEL IMAGE PRINT IN REPORTS
VTube is designed to handle multiple displays. |
NEW - SEPARATE PERSPECTIVE MODES FOR STEP and LASER WINDOWS
In previous versions, there was only a single Perspective Mode switch. |
NEW - REQUEST REVERSE CALC WHEN EXITING THE LRA GRIDS
When you edit the data in the LRA grid, VTube-LASER now assumes that you probably mean to perform a reverse calc. |
FIX - REPAIRED LOSS OF ORIGINAL ORIENTATION DURING REVERSE CALC
VTube always attempts to keep the original XYZ orientation when you perform a Reverse Calc from LRA to centerline XYZ data. |
FIX - BUILD TO SOLIDWORKS ASSEMBLY
VTube would incorrectly build a single tube to both a single part drawing and a SOLIDWORKS ASSEMBLY. |
Other Pages
- See VTube-LASER Addata ZModem Communications Protocol for more information.
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature