Difference between revisions of "Controlling Deadband"
From ATTWiki
(→STEP 1: Create a new CIO) |
(→STEP 3: Insert the COMDEF Name in the PreEnable.cncprocesslist File) |
||
| Line 37: | Line 37: | ||
<td width=500> | <td width=500> | ||
The PreEnable file will run commands before enabling any axis.<br><br> | The PreEnable file will run commands before enabling any axis.<br><br> | ||
| + | |||
| + | <pre> | ||
| + | Set Bend Axis Deadband | ||
| + | Clear Drive Faults On | ||
| + | InputTimer= tim0:250 | ||
| + | Clear Drive Faults Off | ||
| + | </pre> | ||
The file is found in c:\cnc\config\cncprocesslist | The file is found in c:\cnc\config\cncprocesslist | ||
| Line 46: | Line 53: | ||
</tr> | </tr> | ||
</table> | </table> | ||
| − | |||
==Other Pages== | ==Other Pages== | ||
Revision as of 14:57, 9 August 2013
Deadband can be controlled by taking these steps.
Contents |
STEP 1: Create a new CIO
|
Create a new CIO for the servo module in the CIO Editor like this: |
STEP 2: Create a new COMDEF with the new CIO
|
Create a new COMDEF like this: |
STEP 3: Insert the COMDEF Name in the PreEnable.cncprocesslist File
|
The PreEnable file will run commands before enabling any axis. Set Bend Axis Deadband Clear Drive Faults On InputTimer= tim0:250 Clear Drive Faults Off The file is found in c:\cnc\config\cncprocesslist |
Other Pages
- Back to CNC Bender Tutorials
- Back to CNC Bender
