Difference between revisions of "CNC Bender v12-20120622"
From ATTWiki
| Line 19: | Line 19: | ||
<td width=400> | <td width=400> | ||
The ROTATE axis could incorrectly rotate 360 degrees when recovering from safety mat activation under rare circumstances of the rotate drifting way from zero. This has been fixed. | The ROTATE axis could incorrectly rotate 360 degrees when recovering from safety mat activation under rare circumstances of the rotate drifting way from zero. This has been fixed. | ||
| + | <br> | ||
| + | </td> | ||
| + | |||
| + | <td width=300> | ||
| + | |||
| + | </td> | ||
| + | |||
| + | </tr> | ||
| + | </table> | ||
| + | |||
| + | |||
| + | ===[[image:Check.jpg|25px]] Repair - Robot Clear Bit=== | ||
| + | |||
| + | <table cellpadding=10> | ||
| + | <tr valign=top> | ||
| + | <td width=400> | ||
| + | The Robot Clear bit always assumed that the TRUE signal was bit high. But some machines assume the opposite. This has been fixed. | ||
<br> | <br> | ||
</td> | </td> | ||
Revision as of 15:02, 22 June 2012
v12-20111229
|
|
Repair - Recovery Mode Rotate Spin 180
|
The ROTATE axis could incorrectly rotate 360 degrees when recovering from safety mat activation under rare circumstances of the rotate drifting way from zero. This has been fixed.
|
Repair - Robot Clear Bit
|
The Robot Clear bit always assumed that the TRUE signal was bit high. But some machines assume the opposite. This has been fixed.
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
